Autoquip AUTO-TILT PORTABLE TILTER Manual do Utilizador

AUTO-TILT PORTABLE TILTERP.O. Box 1058 • 1058 West Industrial Avenue • Guthrie, OK 73044-1058 • 405-282-5200 •FAX: 405-282-8105 • www.autoqu

10Figure 5 Label 36401511Figure 6A Label 36405280Figure 6B Label 36405290Figure 7 Label 36403830LABEL IDENTIFICATION

11Figure 8 Label 06100028Figure 9 Label 36405190Figure 10 Label 36405200Figure 11 Label 36405300LABEL IDENTIFICATION

12Model Capacity Tilt Angle ForkLengthHeight Weight RaiseTimeSTR 89-20 2000 lbs 89 degrees 42” 33 _” 675 lbs 20 secSTR 89-40 4000 lbs 89 degrees 42” 3

131. Remove all load from the platform. Never block the lift when loaded.2. Raise the tilter by moving the lever in the “UP” direction.3. The mai

14Leg SocketsMaintenance LegLeg StorageFigure 12 Maintenance DeviceBLOCKING INSTRUCTIONS

15OILThe Auto-Tilt is shipped with oil in the power unit. There is no need to fill it.STANDARD DC UNITWARNING!Read and understand all of the in

16OPTIONAL 115/60 AC UNITWARNING!Read and understand all of the instructions carefully beforeproceeding with the installation process.1. The a

17OPTIONAL AIR POWER UNIT UNITWARNING!Read and understand all of the instructions carefully beforeproceeding with the installation process.1.

18Be familiar with this entire operator’s manual before operating this equipment.LOADING TILTER1. Operate this tilter only on a firm, flat surface.2.

19Normally tilters will require very little maintenance. However, a routine maintenanceprogram could prevent costly replacement of parts and/or downt

2Identification and Inspection 3Dangers, Warnings, and Cautions 4Label Identification 8Specifications 12Blocking Instructions 13Installation I

20Oil Viscosity RecommendationsEnvironment(Ambient Temperatures)Recommended OilIndoor location, variabletemperatures (30° - 100° F)10W30 or 10W40Multi

21CYLINDER REPACKING1. Install the maintenance leg. See “Blocking Instructions” section.DANGER!To avoid personal injury, NEVER go under the tilter pl

2210. Install new packing and seals on the piston, rod, and gland nut. Inspect allgrooves and seal surfaces for any imperfections

23CYLCVVFDVFC FLOW CONTROLMPLEGENDMOTORSYMBOL DESCRIPTIONPUMPVF VELOCITY FUSECYL CYLINDERSF SUCTION FILTERRV RELIEF VALVECV CHECK VALVEDOWN VALVE, 12

24VELOCITY FUSE REPLACEMENTDANGER!Do not attempt to remove the velocity fuse until the hydraulic pressure hasbeen removed from the lifting cylinder

25(WHITE)(BLACK)(RED)(ORANGE)24V.L3L1L2L1L23/4 HORSEPOWERMOTOR:115 VOLT1 PHASE60 CYCLE(BY OTHERS)60 CYCLE115 VOLT1 PHASEO.L.T2T3T1L2L1L1L2DN. SOL.ELEC

26AIRREQUIREDFREE AIR)MOTORLUBRICATOR(BY OTHERS).REGULATORSUPPLYAIR OPERATEDRELIEF VALVE, AIR OPERATED DOWNTHE FUNCTION OF CHECK VALVE, (WHEN USED)AIR

27PART NUMBER DESCRIPTIONElectrical30000020 Motor, _ hp , single phase35107910 Prewired Controller, 115 v, _ hp37200240 Battery Charger, 12 v, 10 a480

28DANGER!To avoid personal injury, NEVER go under the tilter platform until the load isremoved and the platform is securely blocked in th

29PROBLEM POSSIBLE CAUSE AND SOLUTIONTilter raises very slowly. • Check for pinched tubing or hose. Where pipe isused, check for obstruction in the

3IDENTIFICATIONWhen ordering parts or requesting information or service on this unit, PLEASE REFERTO THE MODEL AND SERIAL NUMBER. This information is

30PROBLEM POSSIBLE CAUSE AND SOLUTIONTilter won’t lower. • The solenoid may be incorrectly wired, burnedout, not rated for the voltage, or the line

31Tilter lowers slowly. • Check for pinched or broken tubing or hose.Where pipe is used, check for obstruction in theline.• The return fi

4SAFETY ALERTS (Required Reading!)The following SAFETY ALERTS are intended to create awareness of owners,operators, and maintenance personne

5Read and understand this manual and all labels prior to operating orservicing this Tilter. All labels are provided in accordance with ANSIZ535.4.DAN

6WARNING!NEVER stand, sit or ride on the Tilter.WARNING!All warning and information decals should be in place as outlined in the“Label Identification

7CAUTION!Never run the pump for more than a couple of seconds without pumping oil.This applies to low oil conditions, improper motor rotation,

8124710966885Figure 1 Label Placement DiagramAuto-Tilt Portable TilterItem No. Qty Description Part No.1 2 Warning – No Riders 364037072 1 Maintenanc

9Note: Labels shown here are not actual size.Figure 2 Label 36403707 Figure 3 Label 36400257Figure 4 Label 36400661LABEL IDENTIFICA